Water damage in a medical office rarely waits for a convenient time. A supply line bursts overnight, a condensate line backs up over a weekend, a storm drives rain through a roof penetration, or a toilet overflows into the suite below. By the time someone unlocks the door, water may be under the flooring, in the walls and in the ceiling above exam rooms.
What happens in the first 24 to 48 hours largely decides whether this is a few days of drying or weeks of demolition, mold remediation and lost patient days. This guide walks practice managers through what to do, in order, and what is different when the space is a medical office.
First: Make the Space Safe
- Electricity and water do not mix. If water is near outlets, power strips, equipment or electrical panels, keep people out of the area and have power to it shut off by someone qualified to do so safely. Do not walk through standing water to reach a panel.
- Stop the source if you can. Know where the main water shutoff and fixture shutoffs are before you need them. For a roof leak or a problem in another tenant’s space, call the landlord or property manager immediately.
- Watch for slip and ceiling hazards. Sagging ceiling tiles can hold a surprising amount of water and may fall. Keep staff and patients clear.
- Treat sewage as hazardous. If the water came from a toilet, drain backup or floodwater, keep people out of contact with it and leave cleanup to trained professionals with protective equipment.
Decide Which Rooms Can Stay Open
Most water losses affect part of a suite, not all of it. Decide quickly, and write down why:
- Close rooms with standing water, wet ceilings, or any contamination from sewage or floodwater.
- Keep patient routes to open rooms dry, clear and well lit, with no extension cords or drying equipment in walkways.
- Consider whether drying equipment noise, airflow or containment barriers make adjacent rooms unsuitable for procedures.
- Tell the front desk which rooms are out of service so the schedule can be adjusted for the coming days.
Protect What Is Specific to a Medical Office
This is where a medical office differs from any other commercial water loss:
- Sterile supplies and instruments. Sterile packs and supplies that have become wet, or have been stored in a wet area, should not be used. Follow your infection-prevention policy and the manufacturers’ instructions for reprocessing or discarding.
- Medications and vaccines. If the loss affected power to refrigerators or storage areas, follow your vaccine and medication storage emergency plan: keep units closed, record temperatures, and check with the manufacturer before using anything that may have gone out of range.
- Clinical equipment. Any equipment that got wet or sat in a wet area, from exam chairs and procedure lights to sterilizers and computers, should be inspected by its qualified service provider before it is used again. Do not power it on to “see if it works.”
- Patient records. Move paper records out of harm’s way and keep them secured. Restoration crews will be working in your space, so think about who has access to areas where patient information is stored, and involve your privacy officer if records are damaged or need to be handled by an outside vendor.
Document Everything Before It Is Moved
Insurance claims are won or lost on documentation. Before cleanup begins, if it is safe:
- Take photos and video of the source, the water, the affected rooms, ceilings, walls, flooring, equipment and supplies.
- Write down when the problem was discovered, by whom, and what was done.
- Keep damaged items, or photograph them with labels, until your insurer says they can be discarded. Clinical supplies that must be discarded for safety should be photographed and listed first.
- Save every invoice and receipt: emergency services, drying equipment, replacement supplies, temporary space.
Notify the Right People
- Landlord or property manager: most leases require prompt notice. The lease also determines who is responsible for which repairs. Our article on what your medical office NNN lease makes you responsible for explains how that split often works.
- Your insurance carrier or agent: report the loss promptly and ask what they need from you. Florida law sets deadlines for reporting property claims, so do not wait to see how bad it gets.
- Neighboring tenants: water travels. If the source is above or beside you, the other tenant needs to know too.
One Florida-specific point: for residential and commercial property insurance policies issued on or after January 1, 2023, Florida law prohibits assigning post-loss insurance benefits to a contractor or vendor. If a restoration company asks you to sign over your claim, ask questions and check with your agent or attorney before signing anything.
Start Drying Within 24 to 48 Hours
Speed matters because mold can begin growing on wet materials within days. The EPA’s guidance for commercial buildings is built around responding to water damage within 24 to 48 hours, and it is specific about materials:
- Ceiling tiles that get wet are discarded and replaced, not dried.
- Carpet and backing can sometimes be dried if water is extracted and dehumidifiers and fans are used quickly, and the subfloor is dried too.
- Drywall may be dried in place if there is no obvious swelling and the seams are intact; otherwise it is removed and replaced.
Those drying steps apply to clean water. Water from sewage, drain backups or flooding is handled differently, with containment and protective equipment, and porous materials it touched are usually removed. A professional water mitigation company measures moisture inside walls and floors, sets up the right equipment, and documents the drying until materials reach dry standard. Our guide to water mitigation, restoration and mold remediation explains who does what.
Avoid the temptation to run the HVAC system hard to dry the space early on. If the water was contaminated, or if the air handler or ductwork took on water, have the system checked first so it does not spread moisture or contaminants through the suite.
Plan the Repairs Before Demolition Starts
Once the space is dry, the rebuild begins: drywall, flooring, ceilings, cabinets, paint, and any electrical or plumbing repairs. A few things to settle early:
- Which repairs are the landlord’s responsibility and which are yours
- Whether repairs require permits, and which work must be done by licensed contractors
- Whether the repair is a chance to fix the underlying cause, such as relocating a vulnerable supply line or adding a leak sensor
- How to phase the work so the practice can keep seeing patients. Our guide to renovating a medical office while staying open applies here too.
Before the area returns to patient use, confirm that materials were dried or replaced, there is no visible mold or musty odor, affected equipment has been cleared by its service provider, and the area has been cleaned.
A One-Page Checklist for Your Front Desk
- Keep people away from water near electricity; shut off power to the area safely.
- Stop the water source or call the landlord.
- Close affected rooms and adjust the schedule.
- Protect sterile supplies, medications, equipment and records.
- Photograph and document before anything is moved.
- Notify the landlord and insurance carrier.
- Call for professional water mitigation; start drying within 24 to 48 hours.
- Have affected equipment inspected before use.
- Plan repairs, permits and phasing before demolition.
Post it near the main water shutoff, and make sure every location knows where that is.
Frequently Asked Questions
How quickly should water damage in a medical office be dried?
Start within 24 to 48 hours. EPA guidance for commercial buildings is built around that window because mold can begin growing on wet materials within days.
Can we keep seeing patients after a leak?
Often, in the unaffected part of the suite. Close rooms with standing water, wet ceilings or any sewage contamination, keep patient routes dry and clear, and consider noise and airflow from drying equipment near procedure rooms.
Are wet sterile supplies still usable?
Sterile packs and supplies that have become wet should not be used. Follow your infection-prevention policy and the manufacturer’s instructions for reprocessing or discarding them.
Who pays for water damage in a leased medical office?
It depends on the lease, the source of the water and your insurance. The landlord may be responsible for the building and its systems, and you for your improvements, equipment and contents. Report to both the landlord and your carrier promptly.
Does MedServ handle water damage?
Yes. MedServ team members hold IICRC Water Damage Restoration Technician (WRT) certification, and we handle some water mitigation directly and bring in specialist providers for larger or more complex losses. For clients with applicable coverage, MedServ coordinates the full response: water mitigation and restoration, coordinating with the landlord, following the work through to repairs, and keeping the records together for the claim and for the location’s history. During an active leak, protect people first and use the emergency contacts in your own plan and service agreement.
Have a Plan Before the Next Leak
The practices that recover fastest know who to call before something goes wrong. MedServ helps outpatient groups put that plan in place across every location and, for clients with applicable coverage, coordinates the response when it happens. See how emergency support works, or talk to MedServ about setting up a plan for your locations. If water is entering your office right now, follow the steps above and contact your landlord and a water mitigation provider first; this website is not the way to report an active emergency.
